The Pulse High Beam Module is typically mounted near the vehicle's headlight assembly using supplied screws, with connections made to the high beam plug and accessory power wire.

Mounting the Module

The Pulse High Beam Module should be mounted in a secure location close to the headlight assembly. Polaris vehicles often have pre-designated mounting spots for this purpose, but for other vehicles, choose a location that is protected from moisture and heat while allowing easy access to the headlight plug and wiring harness . Use the supplied screws to secure the module firmly.

Wiring Connections

1. Headlight Plug Adapter: Unplug the passenger-side headlight connector and install the supplied adapter. Then, plug the adapter into the headlight and the module harness .
2. Accessory Power Wire: Connect the accessory power wire to the orange and black wire using the supplied heat-shrinkable butt connector. Seal the connection with a heat gun to ensure durability .
3. Relay and Fuse: The module includes a relay with a 20 AMP fuse. Adjust the fuse size according to the accessory's power requirements (can be increased to 30 AMP if needed), .

Operational Verification

After installation, turn the vehicle key on and switch the headlights to high beam. The Pulse High Beam Module should activate the pulsing function of the high beams. Verify that the pulsing pattern works correctly and that all connections are secure .

Additional Tips

• Ensure the module is mounted away from moving parts and extreme heat sources.
• Follow the included wiring diagram carefully to avoid short circuits.
• The pulsing feature is designed to operate only at certain speeds to prevent unwanted activation at low speeds . By following these steps, the Pulse High Beam Module will be properly installed, providing enhanced visibility and a distinctive pulsing effect for safety and style.