To wire sockets from a distribution box, connect the main supply to the main breaker, route branch circuits through individual MCBs, and ensure proper neutral and earth connections for safety.

Step-by-Step Wiring Process

1. Safety First Always turn off the main power supply before starting any wiring work to prevent electrical shock. Use insulated tools and wear protective gear during installation . 2. Mount the Distribution Box Secure the distribution box at an accessible height (typically around 1.5 meters) in a dry, ventilated area. Ensure the box is firmly fixed to the wall and free from obstructions . 3. Connect the Main Supply Attach the incoming live (phase) wire to the main MCB or main switch. Connect the neutral wire to the neutral bus bar and the earth wire to the earth terminal. This ensures the main power is safely distributed to all circuits . 4. Install Circuit Breakers Place single-pole MCBs for socket circuits in the designated slots. For special high-power sockets, double-pole MCBs may be used. Connect the input of each MCB to the output of the main MCB or RCCB, depending on your setup . 5. Wire the Sockets

• Use 2.5mm² wires for standard socket circuits.
• Connect the live wire from the MCB output to the live terminal of the socket.
• Connect the neutral wire from the neutral bus bar to the neutral terminal of the socket.
• Connect the earth wire from the earth bus bar to the socket's earth terminal . 6. Organize and Secure Wires Route wires neatly: typically, wiring between the main breaker and branch breakers goes on the left, and outgoing wires to sockets go on the right. Use plastic ties to bind wires, keeping them straight and evenly spaced . 7. Label and Test Clearly mark each circuit for identification (e.g., “Living Room Sockets”). After wiring, perform a safety inspection using a multimeter to check for continuity, correct voltage, and absence of short circuits . 8. Final Safety Check Ensure all connections are tight, insulation is intact, and no wires are exposed. Verify that the total load does not exceed the capacity of the distribution box or individual MCBs . By following these steps, you can safely wire sockets from a distribution box while maintaining proper organization, protection, and compliance with standard electrical practices.